Using RIS to install Server 2K3

Discussion in 'Windows Networking' started by NLiles, Nov 13, 2007.

  1. NLiles

    NLiles Guest

    I setup a RIS server and created an Image so i can deploy servers via PXE.
    Appairently my HP Proliant DL145 Broadcom NIC cards are not supported by 2K3
    natively. So I downloaded the drivers from HP's site which are listed as RIS
    drivers for the NIC and followed the steps in KB Article: 246184 and this
    still did not solve the issue. I get an error after the PXE boot once it
    enters into the Setup that says there are no valid network card drivers setup
    cannot continue.

    Any ideas?
     
    NLiles, Nov 13, 2007
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.