Using MN500 as Access Point w/ existing MN500

Discussion in 'Broadband Hardware' started by JT, May 19, 2004.

  1. JT

    JT Guest

    Hello-
    I have seen a few posts regarding using an additional MN
    500 as an access point on an existing MN500. Hopefully
    someone can help. I have set the new MN500 to bridging
    mode and changed the IP address to 192.168.2.2 I
    changed the DHCP settings on my existing MN500 so this
    address is not available. I then ran a cable from the
    new MN500 modem port to port 1 on the existing box. I
    can't seem to get this to work. I want to keep one box
    in the basement and the other upstairs. Can this be
    done?

    Do I keep the network names the same of change them? Any
    ideas, thoughts etc. appreciated.

    Thanks,

    JT
     
    JT, May 19, 2004
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.