Routing and Remote Access - Warning 4110, why???

Discussion in 'Windows Networking' started by triding, Jan 7, 2004.

  1. triding

    triding Guest

    I have the same problem did you ever figure it out. When
    I configure the Server for RRAS the general tab does not
    show up just the two policy tabs. When I exit the MMI
    and reenter I get the 4110 message. I can not get
    configure NAT, RAS or VPN with out the general tab. This
    is a clean install of 2k3 with all updates. This system
    will be used strickly as a router so nothing else is
    installed.

    If you or anyone else has any sudgestions let me know.
    Tom
     
    triding, Jan 7, 2004
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.