PCMCIA eth0 and eth1 swap (newbie)

Discussion in 'Linux Networking' started by MatB, Jun 27, 2003.

  1. MatB

    MatB Guest

    Hi, i have 2 network card in the PCMCIA slots: a wifi card in slot 0 and a
    ethernet card in slot 1. These two cards cannot be swapped for mechanical
    problems.
    I'd like to have the ethernet card assigned to eth0, no matter if in the
    slot 0 the wifi card is present or not.
    It would possible, for example, to delay the wifi card at boot time, so
    that it's detected as eth1?
    Thanks,

    MatB
     
    MatB, Jun 27, 2003
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.