Install SW has no Management Tool?

Discussion in 'Broadband Hardware' started by Steve, Jan 24, 2004.

  1. Steve

    Steve Guest

    I installed SW from CD, quitting before going through the
    configuration wizard because I have Wn 2K. There is no
    Base Station Management Tool installed (only a network
    utility tool). Refuses to re-install because the update
    wizard ran during the initial install. Where is the BSMT?
     
    Steve, Jan 24, 2004
    #1
    1. Advertisements

  2. Steve

    Chris H. Guest

    It is at the default IP of the base station, 192.168.2.1, with the default
    password of "admin" without the quotes. Check the User's Guide information
    for installing on Windows 2000.
     
    Chris H., Jan 24, 2004
    #2
    1. Advertisements

  3. Steve

    Steve Guest

    "admin" unrecognized, even after 2 hard resets.
     
    Steve, Jan 24, 2004
    #3
  4. Steve

    Chris H. Guest

    "admin" without the quotes is the default password, all lower case, unless
    you changed it. Are you resetting the base station by holding a pen or
    unfolded paperclip in the Reset slot for more than five seconds? That will
    reset to factory, the default 192.x.x.x address and the admin password.
     
    Chris H., Jan 24, 2004
    #4
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.