enabling Remote Installation Services (RIS) after setup using wizard

Discussion in 'Windows Networking' started by matt.jacobsen, Feb 3, 2005.

  1. Hi,

    Stupid question probably: but how do you set a RIS server to accept
    requests after an install?

    When first running the "RIS Setup Wizard" I was asked if I wanted to
    start accepting RIS installation requests right away (even though I
    hadn't set up any installation images). I chose not to, as I thought
    that there would be no point, and besides that the wizard told me that
    I could (obviously) enable this at a later time.

    So. Now is that later time. Do you know where can I enable this option?

    Kind regards,

    Matt M Jacobsen
     
    matt.jacobsen, Feb 3, 2005
    #1
    1. Advertisements

  2. Steven L Umbach, Feb 3, 2005
    #2
    1. Advertisements

  3. Cheers!
     
    Matt Jacobsen, Feb 10, 2005
    #3
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.