Doubts about routing and NATTING

Discussion in 'Network Routers' started by giovanniparodi79, Jun 11, 2013.

  1. Hello everybody, I have a question related to natting on WinCE.
    I enabled natting on the device and I'm using the following network setup.



    PC_1 with NAT enabled: ip address 192.168.0.1
    PC_2 connected to PC_1, using it as default gateway and static ip address 192.168.0.10

    PC_1 has a GPRS modem and I would like to let PC_2 ping (as first task) an Ip address that PC_1 can reach through the GPRS interface.

    My problem is that when I ping from PC_2 any ip address, I receive a echo from PC_1.
    I think this is an error in route, here is the output of rout print command.

    =============================================================================
    Interface List
    0x2 00 60 3b 0d f5 35 LAN90001
    =============================================================================
    =============================================================================
    Active Routes
    The no. of entries is ::: 9
    Destination Netmask GatewayAddress Interface Metric
    ----------------------------------------------------------------------------
    127.0.0.0 255.0.0.0 127.0.0.1 127.0.0.1 1
    169.254.0.0 255.255.0.0 169.254.125.18 169.254.125.18 20
    169.254.125.18 255.255.255.255 127.0.0.1 127.0.0.1 20
    169.254.255.255 255.255.255.255 169.254.125.18 169.254.125.18 20
    192.168.0.0 255.255.255.0 192.168.0.1 169.254.125.18 20
    192.168.0.1 255.255.255.255 127.0.0.1 127.0.0.1 20
    192.168.0.255 255.255.255.255 192.168.0.1 169.254.125.18 20
    224.0.0.0 240.0.0.0 169.254.125.18 169.254.125.18 20
    255.255.255.255 255.255.255.255 169.254.125.18 169.254.125.18 1
    =============================================================================

    I will appreciate any help.
    Best regards
    Giovanni
     
    giovanniparodi79, Jun 11, 2013
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.