Connecting a PC to a D-Link DSL-300G+ Console port

Discussion in 'Broadband' started by Graham Lally, Jan 10, 2004.

  1. Graham Lally

    Graham Lally Guest

    Hi there,

    Does anyone have any details for connecting a PC to the "Console" port
    of a D-Link DSL-300G+ adsl modem?

    Have tried hooking up an FCC68 4-contact/4-position connector to a DB9
    and connecting via HyperTerm, but to no effect (although not sure
    where a fault, if any, would be in the set-up). Looks like all it
    needs is Ground, RX and TX wires, although I can't find any schematics
    to find out which is TX and which is RX on the modem's connector. The
    4th pin doesn't /look/ like it does anything...

    Something went wrong when saving the config to flash, and the modem
    isn't responding to anything now - no http, telnet or ping. Was hoping
    that a flash upgrade via the console port would help matters, but I
    may have to just see about sending it back.

    Thanks muchly,
    ..g
     
    Graham Lally, Jan 10, 2004
    #1
    1. Advertisements

  2. Graham Lally

    Tiscali Tim Guest

    In an earlier contribution to this discussion,

    Have you tried the D-Link support page at
    http://support.dlink.com/Products/view.asp?productid=DSL-300G ?

    Are you sure that the console port *is* a serial connection? If so, you'll
    need not only to get the wiring right but also to configure with PC's serial
    port with the right baud rate etc.
     
    Tiscali Tim, Jan 10, 2004
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.