Zero Configuration Setting for Wireless Connection

I have to reset my Windows config setting to connect wireless each time the
computer starts. After resetting the setting to "START" in Services (because
it's been reset to "STOP", the "Apply" button is dimmed so I can only click
OK. I think this may be the problem. So then I have to go through all the
steps each time. What's the problem with the "Apply" button being deactive?
--
mickey

Hi
May be this can Help.
http://www.ezlan.net/wzc.html
Jack (MVP-Networking).
"mickey" <(E-Mail Removed)> wrote in message
news:9222F46B-7F19-431E-A16D-(E-Mail Removed)...
>I have to reset my Windows config setting to connect wireless each time the
> computer starts. After resetting the setting to "START" in Services
> (because
> it's been reset to "STOP", the "Apply" button is dimmed so I can only
> click
> OK. I think this may be the problem. So then I have to go through all
> the
> steps each time. What's the problem with the "Apply" button being
> deactive?
> --
> mickey

Thanks a lot. Problem was the Dell LAN was also enabled so I disabled that.
Solved the problem!
--
mickey


"Jack (MVP-Networking)." wrote:

> Hi
> May be this can Help.
> http://www.ezlan.net/wzc.html
> Jack (MVP-Networking).
> "mickey" <(E-Mail Removed)> wrote in message
> news:9222F46B-7F19-431E-A16D-(E-Mail Removed)...
> >I have to reset my Windows config setting to connect wireless each time the
> > computer starts. After resetting the setting to "START" in Services
> > (because
> > it's been reset to "STOP", the "Apply" button is dimmed so I can only
> > click
> > OK. I think this may be the problem. So then I have to go through all
> > the
> > steps each time. What's the problem with the "Apply" button being
> > deactive?
> > --
> > mickey
>
>
>

"mickey" <(E-Mail Removed)> wrote in message
news:9222F46B-7F19-431E-A16D-(E-Mail Removed)...
> I have to reset my Windows config setting to connect wireless each time
> the
> computer starts. After resetting the setting to "START" in Services
> (because
> it's been reset to "STOP", the "Apply" button is dimmed so I can only
> click
> OK. I think this may be the problem. So then I have to go through all
> the
> steps each time. What's the problem with the "Apply" button being
> deactive?

There is no problem with the Apply button.
It is enabled only when one changes the startup type of the service, what
you don't do.
The start and stop are one-time commands that don't affect the permanent
startup type.

The info on MVP Jack's site can help you to find what is tinkering with your
wzcsvc.

Regards,
--PA