Hello all,
I'm new to this forum but I thought someone might be able to help me
with a question I have. I was performing a wireless audit/site survey
to look for any rogue access points on our network and to locate/place
our AP’s on a satellite image of our facilities.
We have two sites that are connected via a wireless bridge 802.11g and
at the root bridge site I see our AP within Ekahau (passive monitoring
software) but at the non root bridge site I come back with no signal
being picked up. These are both setup to bridge only but I should still
be able to passively see traffic which I could from one site but not the
other.
The WAP's are Cisco Aironet 1400 series. Is the reason I'm not seeing
traffic on the far end because of the non-root bridge setting? Could
someone explain why?
Your help is appreciated,
Lee
------------------------------------------------------------------------
View this thread:
http://www.wirelessforums.org/showthread.php?t=30524
http://www.wirelessforums.org
Similar Threads
Linear Mode
