Win98 computer can't see Win XP computer

I added a new computer to my network, but the older one
does not have access to the new one. I'm hoping someone in
this group can help me figure out what I'm doing wrong.

Nadine H.

www.careyholzman.com/netfixes.htm

Carey

"Nadine H" <(E-Mail Removed)> wrote in message
news:003201c3c1a9$d4a51bd0$(E-Mail Removed)...
> I added a new computer to my network, but the older one
> does not have access to the new one. I'm hoping someone in
> this group can help me figure out what I'm doing wrong.
>
> Nadine H.

In article <003201c3c1a9$d4a51bd0$(E-Mail Removed)>, "Nadine H"
<(E-Mail Removed)> wrote:
>I added a new computer to my network, but the older one
>does not have access to the new one. I'm hoping someone in
>this group can help me figure out what I'm doing wrong.
>
>Nadine H.

1. Permanently disable XP's built-in Internet Connection Firewall on
local area network connections -- it's for use only on a direct modem
connection to the Internet. Disable and un-install all other
firewalls while troubleshooting. Details here:

Windows XP Internet Connection Firewall
http://www.practicallynetworked.com/...c_firewall.htm

2. Use only one protocol for File and Printer Sharing. If the network
needs more than one protocol, unbind File and Printer Sharing from all
but one of them. Details here:

Windows XP Network Protocols
http://www.practicallynetworked.com/..._protocols.htm

3. Make sure that NetBIOS over TCP/IP is enabled on all computers.
Details here:

Enable NetBIOS Over TCP/IP (NetBT)
http://www.practicallynetworked.com/...hoot/netbt.htm

4. Run "ipconfig /all" on XP and look at the "Node Type" at the
beginning of the output. If it says "Peer-to-Peer" (which should
actually be "Point-to-Point") that's the problem. It means that the
computer only uses a WINS server, which isn't available on a
peer-to-peer network for NetBIOS name resolution.

If that's the case, run the registry editor, open this key:

HLM\System\CurrentControlSet\Services\Netbt\Parame ters

and delete these values if they're present:

NodeType
DhcpNodeType

Reboot, then try network access again.

If that doesn't fix it, open that registry key again, create a DWORD
value called "NodeType", and set it to 1 for "Broadcast" or 4 for
"Mixed".

For details, see these Microsoft Knowledge Base articles:

Default Node Type for Microsoft Clients
http://support.microsoft.com/default...b;en-us;160177

TCP/IP and NBT Configuration Parameters for Windows XP
http://support.microsoft.com/default...b;en-us;314053
--
Best Wishes,
Steve Winograd, MS-MVP (Windows Networking)

Please post any reply as a follow-up message in the news group
for everyone to see. I'm sorry, but I don't answer questions
addressed directly to me in E-mail or news groups.

Microsoft Most Valuable Professional - Windows Networking
http://mvp.support.microsoft.com

Steve Winograd's Networking FAQ
http://www.bcmaven.com/networking/faq.htm