Why would the IP addy of my WAP54G AP and repeater change..

Been living a horror story since installing WAP54G as AP and WAP45g as
repeater..Went to look at configs today and thier IP addresses were
different. Only found them by trying different IPs..
Could this have something to do with my
" Is anyone other then me using 2 WUSB54G's off the same AP.. I have a
WAP54g and 2 New Dell pc's and am trying to use USB adapters to
connect.. having all sorts of problems, Can't share printer between the

two, Getting "access violation at
address 004075e5 module WUSB54G4.exe of address 00000368" on both PC's
and having connect issues (one or the other drops off the net) " post ?
Thanks ,Ted O.

"Houndog" <(E-Mail Removed)> wrote:
>Been living a horror story since installing WAP54G as AP and WAP45g as
>repeater.

Wait a minute, you've got two of them now, and they aren't acting
right?

>Went to look at configs today and thier IP addresses were
>different. Only found them by trying different IPs..

What IPs do they have now? Did you set the admin passwords? Is it
possible someone is mucking about with your WAPs?

Does everything work if you just have one of them used as an AP?

Don't forget to start a new thread with your response, so we lose
_all_ context... 8*|

>Wait a minute, you've got two of them now, and they aren't acting
>right?

This is my setup ,
At my office I have a wrt54g for 3 computers,and I have a WAP54G as AP
(in my building) and a WAP45g as a repeater.(in the remote building) .
Then I have 2 computers with wusb54g adapters..

>What IPs do they have now? Did you set the admin passwords? Is it
>possible someone is mucking about with your WAPs?

AP was .104, now its .101,, repeater was .105, now its .103..The
passwords have been changed..

"Houndog" <(E-Mail Removed)> wrote:
>At my office I have a wrt54g for 3 computers,and I have a WAP54G as AP
>(in my building) and a WAP45g as a repeater.(in the remote building) .
>Then I have 2 computers with wusb54g adapters..
>
>>What IPs do they have now?

>AP was .104, now its .101,, repeater was .105, now its .103.

Are they getting these thru DHCP from the WRT? Why not set them to
static addresses outside the DHCP pool range of the WRT? They come
from the factory at ...245, I'd leave the AP there and set the router
to ...246 or something.

Thanks William,, will give that a try..