wet 11v2 with poor receive sensivity

I have bought a wet11v2. The receive sensivity was very bad. I found a way
to increase the sensivity by increasing the voltage.
When someone is interested, I can explain how you can do it.

On Sun, 22 Aug 2004 21:23:33 GMT, "Frans" <(E-Mail Removed)> wrote:

>I have bought a wet11v2. The receive sensivity was very bad. I found a way
>to increase the sensivity by increasing the voltage.
>When someone is interested, I can explain how you can do it.

Sure. I need some entertainment value. The WET11 runs internally on
3.3VDC. The external power supply can be anything between about
4.5VDC and about 10VDC. The switching regulator chip can handle
perhaps 30VDC, but the input filter cazapitor is rated at 10VDC and
will probably explode if you try anything higher than 10VDC. Unless
your 5VDC wall wart is producing insufficient voltage (this does
happen), methinks a voltage increase will do nothing.

There are a few other WET11 hacks and tweaks that might be of
interest:
http://www.seattlewireless.net/index.cgi/LinksysWET11
Also see the PoE section.

--
Jeff Liebermann (E-Mail Removed)
150 Felker St #D http://www.LearnByDestroying.com
Santa Cruz CA 95060 AE6KS 831-336-2558