VPN to cisco pix/w2k domain....

Hello
I am setting up a vpn for remote access to a windows 2000 domain. I am using a cisco pix 515E version 6.3(3) as the connection that users will vpn to. I have been able to establish a vpn to the pix ok but now I need to figure out how to get users logged on to the windows domain so they have the correct network access. It looks like the best choice is TACACS+??
Does anyone with a similar setup have advice about where my next steps should be

Thanks

Joe

>Hello

I am setting up a vpn for remote access to a windows 2000 domain. I am using a cisco pix 515E version 6.3(3) as the connection that users will vpn to. I have
been able to establish a vpn to the pix ok but now I need to figure out how to get users logged on to the windows domain so they have the correct network
access. It looks like the best choice is TACACS+??

Does anyone with a similar setup have advice about where my next steps should be



Thanks



Joe
>
Joe,

RADIUS will do this as well. You can set the PIX as a RADIUS client to the Windows 2000 or 2003 Domain Controller running Internet Authentication Server
(IAS) and this will allow you to authenticate users against AD.

816586 HOW TO: Configure a Primary Internet Authentication Service Server on a
http://support.microsoft.com/?id=816586

T.J. Campana [MSFT]
Microsoft EPS Networking
--
This posting is provided "AS IS" with no warranties, and confers no rights. Use of included script samples are subject to the terms specified at
http://www.microsoft.com/info/cpyright.htm

Note: For the benefit of the community-at-large, all responses to this message are best directed to the newsgroup/thread from which they originated.