Using RIS to install Server 2K3

11-13-2007, 05:16 PM

I setup a RIS server and created an Image so i can deploy servers via PXE.
Appairently my HP Proliant DL145 Broadcom NIC cards are not supported by 2K3
natively. So I downloaded the drivers from HP's site which are listed as RIS
drivers for the NIC and followed the steps in KB Article: 246184 and this
still did not solve the issue. I get an error after the PXE boot once it
enters into the Setup that says there are no valid network card drivers setup
cannot continue.

Any ideas?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to install the Radius Server Cert. to PDA ?	Mark	Wireless Networks	0	03-07-2006 08:19 AM
RIS / PXE Server 2003 with remote install	BK	Windows Networking	0	09-12-2005 02:22 PM
Cannot connect to external FTP server after SP1 install	=?Utf-8?B?Sm9obiBZZXNraQ==?=	Windows Networking	0	04-12-2005 07:27 PM
How to install TCP/IP Print server service in Windows 2003 server	=?Utf-8?B?RE1J?=	Windows Networking	1	11-08-2004 07:38 PM
Re: How to configure a server for a NFS install	y..o	Linux Networking	0	06-24-2003 05:32 PM