using network boot to install RedHat using Anaconda

Mike

Guest

Posts: n/a

02-09-2004, 06:05 PM

Howdy.

I'm currently using the ks.cfg (anaconda) configuration to automate
redhat installes for various machines, but would like to take this one
step further to remove the need for CDROM drives in the machines.

Is it possible (and not too hard to setup) to use LTSP or ?? to set a
machine to network boot the RedHat CD image? Then all I'd have to do
is put in the ks.cfg path and the rest would take care of itself.

Thanks.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Redhat PXE boot problems	billshaf@hotmail.com	Linux Networking	0	08-02-2006 03:47 PM
Can't get PCI Network Card to Work - Knoppix 4.0.2/Redhat 7.2/Redhat 8.0	deja@chronofish.com	Linux Networking	0	11-20-2005 05:02 PM
Network install Redhat	Siva Palaninathan	Linux Networking	4	11-09-2004 07:49 PM
RE: 90 second 0S boot delay after net card install	Gary	Windows Networking	4	07-13-2003 04:20 PM
Boot from EEPROM @ PCI-Card --> Boot from DHCPD/BOOTPD via Linux	Daniel Schwager	Linux Networking	3	07-06-2003 04:35 PM