"Unable to connect to wireless network" message

05-08-2005, 07:54 PM

I have 5 PC's connected through a Lynksys BEFW1154 V2 wireless router. Each
PC has its own USB Linksys WUSB1.1 V2.6 wireless adapter, so each connects
to the internet separately. On bootup with 2 PC's I frequently get the
unable to connect message. I do a repair, and both connect when the IP
address is refreshed. Both PC's IP address are set up manually, because when
windows automatically sets up an address there are frequently conflicts with
with other PC's IP address. Any ideas would be appreciated.

05-09-2005, 05:40 AM

"jacmac101" wrote:

> I have 5 PC's connected through a Lynksys BEFW1154 V2 wireless router. Each
> PC has its own USB Linksys WUSB1.1 V2.6 wireless adapter, so each connects
> to the internet separately. On bootup with 2 PC's I frequently get the
> unable to connect message. I do a repair, and both connect when the IP
> address is refreshed. Both PC's IP address are set up manually, because when
> windows automatically sets up an address there are frequently conflicts with
> with other PC's IP address. Any ideas would be appreciated.
>
>
>

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
error message "Unable to display the user selection dialog"	Matt	Windows Networking	0	02-15-2007 02:49 AM
SHared Printer has message: Unable to connect"	Tony V	Wireless Networks	0	08-03-2006 06:25 PM
After XP SP2, Linksys wireless "unable to connect", disabled WZC	Cath	Wireless Networks	1	10-01-2004 10:41 PM
MN-100 Error Message "unable to install ... a newer version already installed"	djbartu	Broadband Hardware	2	04-02-2004 03:54 PM
Airlink+ 802.11b PCI unable to connect to network, and internet, despite "excelent" signial strength	Matt	Wireless Internet	2	01-02-2004 04:36 PM