Ubiquiti SRC & MadWifi

Hi folks !

I have an Ubiquiti Super Range Card and I wanna use it under Linux
System.. so I've downloaded MadWifi NG, Madwifi was succesfully
installed.
Card is detected as "ath0"..but when I perform a "iwlist ath0 scan" the
result is "no scan result" in every case..and I've noticed that Tx/Rx
Power is set to 0 !
So...I've downloaded Madwifi Old Version and in this case the card
seems to work but with less less power than effective power (300 mw).
Do you know what could be the problem?

I use a PowerBook G4 with Slackintosh 12.0 .

Thanks

Ciao


------------------------------------------------------------------------
View this thread: http://www.wirelessforums.org/showthread.php?t=33440
http://www.wirelessforums.org

Filo_Flame wrote:
> Hi folks !
>
> I have an Ubiquiti Super Range Card and I wanna use it under Linux
> System.. so I've downloaded MadWifi NG, Madwifi was succesfully
> installed.
> Card is detected as "ath0"..but when I perform a "iwlist ath0 scan" the
> result is "no scan result" in every case..and I've noticed that Tx/Rx
> Power is set to 0 !
> So...I've downloaded Madwifi Old Version and in this case the card
> seems to work but with less less power than effective power (300 mw).
> Do you know what could be the problem?

Did you take into account the "power offset"?
http://www.ubnt.com/downloads/SRXR_power_offset.pdf



>
> I use a PowerBook G4 with Slackintosh 12.0 .
>
> Thanks
>
> Ciao
>
>
> ------------------------------------------------------------------------
> View this thread: http://www.wirelessforums.org/showthread.php?t=33440
> http://www.wirelessforums.org
>