«

I need to install a Cisco A/P and two Cisco ANT1728 antennas.

The antennas have a threaded hole in them for mounting which would be
used to attach them to the stud of a supplied T bar clip.

I need to devise a different mount instead of the T bar clip. I don't
have the antennas yet and need to install as soon as I get them so I was
trying to have what I need on hand.

http://www.cisco.com/en/US/docs/wire...e/ant1728.html

On 7/23/2010 12:28 PM, Jeff Liebermann wrote:
> On Fri, 23 Jul 2010 08:59:36 -0400, George<(E-Mail Removed)>
> wrote:
>
>> I need to install a Cisco A/P and two Cisco ANT1728 antennas.
>>
>> The antennas have a threaded hole in them for mounting which would be
>> used to attach them to the stud of a supplied T bar clip.
>>
>> I need to devise a different mount instead of the T bar clip. I don't
>> have the antennas yet and need to install as soon as I get them so I was
>> trying to have what I need on hand.
>>
>> http://www.cisco.com/en/US/docs/wire...e/ant1728.html
>
> I don't have one of these antennas, but I think I can guess the thread
> size. The above URL specifies using a 7/16" wrench on the nut. That
> neatly fits a common 1/4-20 nut.
>
> Disclaimer: This is only a guess.
>

Good guess, I bought some beam clamps at the local electrical supply
house and used a small bolt in the "wrong" direction as a stud.