Telephone interference

I recently installed a Linksys WMB54G musical bridge. Since the
installation, I'm getting a crackling noise interference on my cordless
phone when I'm in the same room that has the bridge. I've been using the
Uniden 2.4GHz phone system with no interference from my LinkSys wireless
system.

Any ideas why the bridge would cause interference? Also, is there a simple
way to correct the problem.

Thanks in advance for any help,
Bill

On Sat, 22 Jul 2006 09:37:08 -0400, "Bill & Debbie"
<(E-Mail Removed)> wrote in <e9t9md$vo1$(E-Mail Removed)>:

>I recently installed a Linksys WMB54G musical bridge. Since the
>installation, I'm getting a crackling noise interference on my cordless
>phone when I'm in the same room that has the bridge. I've been using the
>Uniden 2.4GHz phone system with no interference from my LinkSys wireless
>system.
>
>Any ideas why the bridge would cause interference?

More traffic. Stronger signal.

>Also, is there a simple
>way to correct the problem.

Switch to 5 GHz phones. Be sure not to get ones that also use 2.4 GHz.

--
Best regards, FAQ for Wireless Internet: <http://Wireless.wikia.com>
John Navas FAQ for Wi-Fi: <http://wireless.wikia.com/wiki/Wi-Fi>
Wi-Fi How To: <http://wireless.wikia.com/wiki/Wi-Fi_HowTo>
Fixes to Wi-Fi Problems: <http://wireless.wikia.com/wiki/Wi-Fi_Fixes>

On Sat, 22 Jul 2006 09:37:08 -0400, "Bill & Debbie"
<(E-Mail Removed)> wrote:

>I recently installed a Linksys WMB54G musical bridge. Since the
>installation, I'm getting a crackling noise interference on my cordless
>phone when I'm in the same room that has the bridge. I've been using the
>Uniden 2.4GHz phone system with no interference from my LinkSys wireless
>system.

Well, you were nice enough to supply the model number of the musical
bridge. Could I trouble you to do the same for the "linksys wireless
system" which I presume is a wireless router?

Also, the model number of the Uniden phone so I can check if it's a
frequency hopper, DSSS, or just plain FM. If it says "DSS", it's
probably a frequency hopper which will clobber the entire 2.4GHz band.

>Any ideas why the bridge would cause interference? Also, is there a simple
>way to correct the problem.

Keep the phone and the wireless stuff physically seperated.
Experiment with different wireless channels.
Get a 900MHz or 5.7GHz cordless phone. They now quite cheap.
Connect a directional antenna on the WMB54G that points away from the
cordless phone.

--
# Jeff Liebermann 150 Felker St #D Santa Cruz CA 95060
# 831-336-2558 (E-Mail Removed)
# http://802.11junk.com (E-Mail Removed)
# http://www.LearnByDestroying.com AE6KS