Netgear WG511 with Dlink DI 624

Two computer's internet connection works using the router
via connecting to the integrated 4 port switch. But once
I install the wireless Netgear card software and card, I
can't connect to internet anymore. And when I uninstall
the software, and return to using the nic, it can't
connect to internet. The only way I can use the nic again
is if I do system restore and everything works again with
the nic. I'm running Xp home, firewall is not enabled. I
get good strength between card and router. But when I do
check the IP, it assigns a number that is not what the
router assigned. I have SBC DSL dynamic IP. Anyone has
suggestions?

You should ask your questions in a Netgear or Dlink forum. This newsgroup
supports Microsoft's Broadband Networking hardware and software only, not
networking in general.
--
Chris H.
Microsoft Windows MVP
Associate Expert
Expert Zone - www.microsoft.com/windowsxp/expertzone

<(E-Mail Removed)> wrote in message
news:1350301c3f744$2984ed40$(E-Mail Removed)...
> Two computer's internet connection works using the router
> via connecting to the integrated 4 port switch. But once
> I install the wireless Netgear card software and card, I
> can't connect to internet anymore. And when I uninstall
> the software, and return to using the nic, it can't
> connect to internet. The only way I can use the nic again
> is if I do system restore and everything works again with
> the nic. I'm running Xp home, firewall is not enabled. I
> get good strength between card and router. But when I do
> check the IP, it assigns a number that is not what the
> router assigned. I have SBC DSL dynamic IP. Anyone has
> suggestions?