Thanks TW. I made it work with D-Link tech service. However, I had to remove
network security . Printer works fine if there is no password for wireless
network. That is probably D-Link problem. I think I will figure it out.
Thanks again.
"TW" wrote:
> Try installing the printer on the parallel port(LPT1) as a locally attached
> printer. You will probably get errors that the printer is not attached, but
> you can continue anyway and install it that way.
> After installing the printer go to the printer properties | ports and
> change the port from LPT1 to an IP port and key in the static IP address.
> Hope this helps
> TW
>
> "KostaM" <(E-Mail Removed)> wrote in message
> news:1BDA6A4B-550E-4EE8-870E-(E-Mail Removed)...
> > Hi I bought D-Link print server which requires static IP address to work.
> > I
> > made it see and connect to my WLAN but when I try to setup a printer,
> > print
> > server can not be found on the network. MN-500 is in router mode with
> > default
> > IP: 192.168.2.1, DHCP is enabled on MN-500 and assigns addresses from
> > 192.168.2.2 - 40. D-link Print Server is manually assigned 192.168.2.41.
> > Any
> > ideas?
>
>
>
|
Similar Threads
Linear Mode
