SP2 RIS to WDS conversion - pxeboot.com i smissing

A few days ago, I upgraded the server 2003 running RIS to SP2. I have run
through all the steps I can find to finish the conversion to WDS.

Now when I boot a PXE client, it gives these error messages:
PXE-T01: File not found
PXE-E3B: TFTP Error - File not Found

I went to the WDS console and then the properties of the Windows Deployment
Services boot properties page. Under x86 architecture, it was defaulted to
boot\x86\pxeboot.com. I searched the drive and there is no file named
pxeboot.com. I changed it to Boot\x86\wdsnbp.com. This allowed the PXE
client to at least give another message. It then starts trying to hit the
info for the x64 client.

Any ideas on where to go from here? If anyone has been able to get it to
work woudl you look and see of pxeboot.com is anywhere on your disk? I just
want it to be able to let a remote client boot like it did before I applied
SP2.

Thanks!

Arch

If you set the path to /oschooser/i386/startrom.com it behaves like before in legacy mode. I have the same problem as you.

EggHeadCafe.com - .NET Developer Portal of Choice
http://www.eggheadcafe.com