SnapGear SG300 Setup VPN to work with TheGeenBow Client

Hi

I have got this scenario ,,,netgear ADSL modem router connected to my ISP, its LAN ip address 192.168.1.1 and one of its LAN port connected to a WAN port (192.168.1.2) of a SnapGear SG300 (please see the link below for this router)

http://www.snapgear.com/index.cfm?skey=1556

LAN ip address for the SnapGear SG300 is 192.168.0.1

http://www.scribd.com/doc/3800513/Ne...-Configuration

In the link above I was able to configure TheGreenBow VPN Client to connect to a Netgear router FVS318

but in my this scenario I do not have Netgear router FVS318, instead I have got Snap Gear SG300,,,,,,I did my best to configure the IPSec for SnapGear SG300 as in the snapshots below (I could not figure out where is my mistake), my confusion during VPN configuration I have to use many IP addresses, but I was not sure which one should I choose (be aware there is double natted ).

Can someone walkthrough the snapshots below to help me out if he/she finds any incorrect settings

1- Tunnel settings

Imageshack - tunnelsettings

2- Local Endpoint settings

Imageshack - localendpointsettings

3- Remote Endpoint Settings

Imageshack - remoteendpointsettings

4- Phase 1 Settings

Imageshack - phase1settings

5- Phase 2 Settings

Imageshack - phase2settings


I used TheGreenBow VPN client utility ,,,,,my configuration as below :
1- Phase1advanced

Imageshack - phase1advanced

2- Phase1 Authentication

Imageshack - phase1authentication

3- Phase 2

Imageshack - phase2b

By looking at those snapshots I would appreciate any hint or tip where I did misconfigure although I will try to post logs for both router and TheGreenBow.
Thanks