Henning Sørensen skrev:
> Have following situation:
> DSL connected to Linksys WRT54G-EU
> Accesspoint Linksys WAP54G-EU
> Everything working fine
>
> Would like to:
> Setup a Topcom WBR611 router as a wireless accesspoint
> to connect wireless to the WAP54G-EU.
>
> So far:
> Have managed to make the WBR611 work as a wired
> accesspoint (cabling to switch).
> Have flashed WBR611 with latest firmware (1.04).
>
> Is there any way to make the WBR611 work wireless?
>
> Any comments will be received with thanks!
>
> Brgds
> Henning - Denmark.
>
>
> ----------------------------------------
> Jeg beskyttes af den gratis SPAMfighter til privatbrugere.
> Den har indtil videre sparet mig for at få 0 spam-mails.
> Betalende brugere får ikke denne besked i deres e-mails.
> Hent gratis SPAMfighter her: www.spamfighter.dk
>
>
Hi Henning
Ive played around with the Linksys AP so i can only give advice on that one.
- I would set up the TopCom AP and connect it to your LAN - check that
you can connect to your wired LAN through it.
- Configure the Linksys in "AP CLIENT mode" and have a go at connecting
to your TopCom wireless AP.
This is done in the webinterface of the Linksys: SETUP --> AP mode and
select "AP Client" and then click "Site Survey" and hopefully you should
be able to connect to your TopCom AP.
If theres no wireless lans showing up - try experimentating with using
same channel and type of standard (A,B and G)most AP's gives you the
option to select a fixed speed.
I usually start out without no encryption on the Wlan - set up the
connection and then applying protection after i got the communication
running - usually makes it easier to diagnose if there is trouble.
Hope i sent you in the right direction
Bitflux
Similar Threads
Linear Mode
