Senao ECB-3220 Wireless Problem

Hi,
I am having Senao ECB-3220 wireless../ Yesterday I updated its firmware
with NCB-3220 from Senao site. Everything went fine../ I was able to
configure it as AP../ Finally, when I change the wireless from AP to
bridge mode, it displayed that the ip has been changed to
192.168.1.1../ I then tried to open the page using same IP../ But after
then everything was dead../ I can't open the site and even I can't ping
the IP of the device../ Though using arp I can see the IP address with
it's mac but no success../ I resetted the device several times using
its reset button, but no improvement../ Can anybody help me out..? is
the device totally dead..?



I would be happy if somebody could help me out../

Rgds,
Dhiren


------------------------------------------------------------------------
View this thread: http://www.wirelessforums.org/showthread.php?t=25942
http://www.wirelessforums.org