SecuRemote/VPN and WinMe

I have a Netgear Router connected to a cable modem and my
WinMe system. My connection to the Internet works great,
however work uses Checkpoint VPN SecurClient to
authenticate it's users. I get the VPN-1 SecureClient
Authentication window to popup and I'm authenticated, but
then I receive a 'page not found' error message when it
tries to connect to work.

I have a laptop that if I forget to start the 'Checkpoint
SecuRemote Service' and 'Checkpoint SecuRemote Watchdog' I
receive the 'page not found' response. Is there something
similar in WinMe? Any suggestions would be appreciated.

Thanks!

>-----Original Message-----
>I have a Netgear Router connected to a cable modem and my
>WinMe system. My connection to the Internet works great,
>however work uses Checkpoint VPN SecurClient to
>authenticate it's users. I get the VPN-1 SecureClient
>Authentication window to popup and I'm authenticated, but
>then I receive a 'page not found' error message when it
>tries to connect to work.
>
>I have a laptop that if I forget to start the 'Checkpoint
>SecuRemote Service' and 'Checkpoint SecuRemote Watchdog'
I
>receive the 'page not found' response. Is there something
>similar in WinMe? Any suggestions would be appreciated.
>
>Thanks!
>.
>

I found the answer! Apparently the default DHCP pool of
addresses has to be changed. By default it assigns a range
of 192.168.0.2 through 192.168.0.51 with the default route
of 192.168.0.1 and this will cause problems. So change it
to for example 192.168.30.2 through 192.168.30.51 with the
default route of 192.168.30.1 and it should work. It did
for me!