Routing question, how to duplicate route table in new distro?

I got help with making pppoe work in fedora core 3, now to get masquerade
working, I need the same routing table added to fc3. Here is my exisiting
route table from rh9:

Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
65.14.252.2 * 255.255.255.255 UH 0 0 0
ppp0
192.168.0.0 * 255.255.255.0 U 0 0 0
eth1
169.254.0.0 * 255.255.0.0 U 0 0 0
eth1
127.0.0.0 * 255.0.0.0 U 0 0 0
lo
default 65.14.252.2 0.0.0.0 UG 0 0 0
ppp0

I am not good with adding routes, how could this be done in fedora core
3? I used the firestarter wizard to get masqerading done and that is how
I got setup in redhat 9, firestarter clogs up the syslogs with usless
traffic info, would rather not use firestarter anymore. Thank you.

--
~Ohmster
ohmster at newsguy dot com

Ohmster <(E-Mail Removed)> wrote in
news:Xns96507CCBE5923MyBigKitty@216.77.188.18:

> I am not good with adding routes, how could this be done in fedora core
> 3? I used the firestarter wizard to get masqerading done and that is how
> I got setup in redhat 9, firestarter clogs up the syslogs with usless
> traffic info, would rather not use firestarter anymore. Thank you.

I broke down and used firestarter-1.0.3-1 to setup the route and firewall.
Sure did a good job, the new firestarter is nice, but it "craps up the
syslogs" as before. Fixed the route table right up though.

--
~Ohmster
ohmster at newsguy dot com