Yes, you are right. It is a Modem/Router and it says at the back as under:
Features:1Eth+1USB;ADSL2+Router.
As advised in EZLAN.NET page, I had already tried to set up the Wireless
Router as an Access Point and occasionally it worked. I understood the First
& Second Step but perhaps, I did not understand the Steps correctly! Under
First Step it says to "change the IP Address of the Router (D-Link) so that
it's in the same subnet as the main Router (Black Box) the one that is
connected to the Internet Modem. So, I opened the D-Link's Configuration
Utility by entering
http://192.168.0.1 and changed it to 192.168.2.1 - the
same as that of the main Router and also unchecked UPnP and DHCP Server.
So, where have I gone wrong?!
Thanks again
Regards
Capt K Ripendran
"Jack-MVP" <(E-Mail Removed)> wrote in message
news:(E-Mail Removed)...
> Hi
> The IP numbers indicate that you have three Routers and three independent
> Networks.
> Your Modem is probably a Modem/Router, creating a network with Subnet
> 192.168.1.x
> Your Black Box creating a second network with Subnet 192.168.2.x, and your
> D-Link is probably Not configured correctly as an Access Point and
> creating a third subnet 192.168.0.x.
> I am Not familiar with your black Box installation and if it is working OK
> leave it as is. However you D-link should be configured following the info
> on this page.
> Using a Wireless Router as a switch with an Access Point -
> http://www.ezlan.net/router_AP.html
> Jack (MS, MVP-Networking)
>
> "Capt K Ripendran" <(E-Mail Removed)> wrote in message
> news:(E-Mail Removed)...
>>I have a Compaq Presario desktop pre-loaded with Win XP Home Edition . It
>>now has SP3.
>> I also have a Dell desktop and a Acer notebook - all with Win XP SP3. I
>> have a 256 Kpbs broadband connection. I have a 4 port Black Box wired
>> Router with Wired connections to all three PC's. I now want to shift the
>> Notebook to another room where it is not practicable to have a wired
>> connection. So, I got a D-Link wireless Router to use as an Access Point.
>> I have followed the instructions given in the D-Link User Manual to use
>> it as a wireless access point by connecting it to Black Box Ethernet
>> Router.
>>
>> DSL Modem's LAN IP Address is:192.168.1.1
>> The Internet IP Address is: 192.168.1.2
>> LAN IP Address of Black Box Router is: 192.168.2.1
>> LAN IP Address of D-Link Router is: 192 168.0.1
>>
>> Using the Configuration utility, I had changed the settings of D-Link
>> Router(Access Point) to the same as that of the Main Router (Black Box).
>> It works well but occasionally there is conflict between the Dell and the
>> Acer and I am unable to access the WebPages!
>>
>> What could be the reason and what is the solution?
>>
>> Thanking you
>> Regards
>> Capt K Ripendran
>>
>>
>
Similar Threads
Linear Mode
