repeater problem with wap11

I have a wap11 v2.2 flashed with dwl-900AP+ firmware. Seems to work ok. But
I am testing the repeator function and it doesn't seem to be working.

I have a belkin 54g router. I try to repeat that router with the same ssid
and installing the correct mac address. I get a much better signal and can
connect but get no internet....

Any ideas? Is it because one is a 802.11g signal and the other 802.11b. I
know this is not a "same product" setup but was wondering if any one had
done some setups like this.

I had a similiar problem where I had a strong wireless signal, but could not
connect to the internet.

This worked for me:

On the wireless computer: Go to Control Panel / Network and bring up the
TCP/IP Properties for your Wireless card. Go to the DNS Configuration Tab
and select Enable DNS. For the Host Name, I have CTED5 and I had to add the
following two IP addresses:
198.6.1.1
204.177.32.2

These are UUNet IP address. I am not sure if they are unique to your ISP,
but I think they will get you on the net.

--
Norm

maybe this will help?

http://www.smallnetbuilder.com/Secti...le34-page1.php

Bill M.

"Norm" <(E-Mail Removed)> wrote in message
news:0pednaRaW6HUQTncRVn-(E-Mail Removed)...
>I had a similiar problem where I had a strong wireless signal, but could
>not connect to the internet.
>
> This worked for me:
>
> On the wireless computer: Go to Control Panel / Network and bring up the
> TCP/IP Properties for your Wireless card. Go to the DNS Configuration Tab
> and select Enable DNS. For the Host Name, I have CTED5 and I had to add
> the following two IP addresses:
> 198.6.1.1
> 204.177.32.2
>
> These are UUNet IP address. I am not sure if they are unique to your ISP,
> but I think they will get you on the net.
>
> --
> Norm
>