On Sat, 11 Dec 2010 20:33:02 -0000
"Peter Crosland" <(E-Mail Removed)> wrote:
> I have one of these running exactly as I want it to. Having acquired
> a second one I effectively wanted to clone the settings from the
> first. Having done that I wanted to make the necessary changes so
> that they can co-exist on the same network by changing the IP
> settings and SSIDs. When I try to do this I am thwarted by an error
> message stating the LAN address is wrong or that the subnet is
> incorrect. One of the difficulties is that the firmware forces each
> separate part of the settings to be saved rather than allowing all
> the settings to be altered and then saved. I am sure that the
> solution is staring me in the face but as usual in these sort of
> circumstances I can't see what is wrong. For example the router IP is
> set to 192.68.1.5 with a subnet mask of 255.255.255.0 and on the
> cloned one I want to change this to 192.168.1.6. but the error LAN
> subnet conflicts with WAN subnet. Both subnet masks are set to
> 255.255.255.0 and in any case I can't find any other setting for the
> subnet. Constructive suggestions welcome.
So what are the WAN settings, because that's what the error message is
complaining about? You're not trying to point it at the other router,
are you?
|
Similar Threads
Linear Mode
