Power light will not go to green MN-700

Not sure what to try next...I'm trying to reinstall my
wireless network base station on a new machine. I've got
my Cable Modem working fine and internet is going, but I
can't seem to get the power light on the MN-700 base
station to stop blinking orange....hence setup is not
recognizing it to install firmware.

I tried resetting to original factory settings on the
back of the base station since my previous machine was ME
and the new machine is XP...

Any help would be awesome!

"Shannon Erman" <(E-Mail Removed)> wrote in message
news:6b9501c4940d$e5943e80$(E-Mail Removed)...
> Not sure what to try next...I'm trying to reinstall my
> wireless network base station on a new machine. I've got
> my Cable Modem working fine and internet is going, but I
> can't seem to get the power light on the MN-700 base
> station to stop blinking orange....hence setup is not
> recognizing it to install firmware.
>
> I tried resetting to original factory settings on the
> back of the base station since my previous machine was ME
> and the new machine is XP...
>
> Any help would be awesome!

Try powering down for several minutes or so. Turn it back on but don't hook
it up to anything. If the POST does not complete to where the green light
comes on, you may have a defective unit. If the MN 700 is still under
warranty you may be able to get it repaired or perhaps take it back to where
you purchased it. These units are getting hard to find since MS is no
longer in the wireless networking hardware business.