Port Fwding not working on MN-700

I'm using the MN-700 with a DHCP client behind it.
I have persistant port forwarding (port 80) from the
MN-700 to the IP of the DHCP client.
I can open port 80 via the DHCP client IP address. I
cannot open port 80 using the WAN address which is how my
buddies can reach my page.
All was working fine prior to installation of MN-700.
I have updated all the firmware/boot software and powered
up/down cable modem and MN-700. I've rebooted the client
and checked the DHCP ip addresses.
From the dhcp client box, I can ping the local IP address
of the MN-700 and have perfect Internet connectivity.
I cannot traceroute or ping the WAN IP address of the MN-700.

The MN-700 Doesn't have loopback support. Try something like
http://www.network-tools.com and that will work.

Bob Fahey wrote:
> I'm using the MN-700 with a DHCP client behind it.
> I have persistant port forwarding (port 80) from the
> MN-700 to the IP of the DHCP client.
> I can open port 80 via the DHCP client IP address. I
> cannot open port 80 using the WAN address which is how my
> buddies can reach my page.
> All was working fine prior to installation of MN-700.
> I have updated all the firmware/boot software and powered
> up/down cable modem and MN-700. I've rebooted the client
> and checked the DHCP ip addresses.
> From the dhcp client box, I can ping the local IP address
> of the MN-700 and have perfect Internet connectivity.
> I cannot traceroute or ping the WAN IP address of the MN-700.

The MN-700 is not port forwarding port 80 to my DHCP
client, although I've set it up that way. I will do some
network captures and see what is happening on the wire.

>-----Original Message-----
>The MN-700 Doesn't have loopback support. Try something
like
>http://www.network-tools.com and that will work.
>
>Bob Fahey wrote:
>> I'm using the MN-700 with a DHCP client behind it.
>> I have persistant port forwarding (port 80) from the
>> MN-700 to the IP of the DHCP client.
>> I can open port 80 via the DHCP client IP address. I
>> cannot open port 80 using the WAN address which is how
my
>> buddies can reach my page.
>> All was working fine prior to installation of MN-700.
>> I have updated all the firmware/boot software and
powered
>> up/down cable modem and MN-700. I've rebooted the client
>> and checked the DHCP ip addresses.
>> From the dhcp client box, I can ping the local IP
address
>> of the MN-700 and have perfect Internet connectivity.
>> I cannot traceroute or ping the WAN IP address of the
MN-700.
>
>.
>