Placing HostAP drivers into Managed mode

Chris Fowler

Guest

Posts: n/a

09-24-2003, 04:15 PM

I've been using the orinoco drivers for my Linksys card
in Managed mode. I wanted to switch to HostAP drivers so
I can run as an Access Point as needed. I've loaded up the
drivers and issued 'iwconfig wlan0 mode Managed". Iwconfig
shows me the card in Managed mode but it will not connect up
to an AP. If I remove the hostap_cs drivers and load the
orinoco_cs drivers then it will connect. Should I only use
hostap as an Access Point?

Thanks,
Chris

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Placing Win2003 Ent DHCP server into 192.254.x.x subnet	parahumanoid	Windows Networking	2	05-16-2007 06:51 AM
hostap drivers as Access Point	Captain Dondo	Linux Networking	2	07-31-2006 02:55 AM
Placing ioctl in a kernel module ?	vivekaseeja@gmail.com	Linux Networking	5	05-15-2006 04:06 AM
how to get an ip address from DHCP in managed mode ?	vivekaseeja@gmail.com	Linux Networking	0	04-22-2006 06:46 PM
Linux orinoco drivers with monitor mode built in?	Scott	Wireless Internet	0	06-25-2003 06:25 PM