pcmcia orinoco gold in monitor mode?????

Hi,

I am having trouble with getting my orinoco card into monitor mode.

Here is my setup:

2.6.11-auditor-10 kernel
Orinoco Gold with 8.72 (also tried 8.10) firmware

hi, i have installed linux auditor version kernel recevied by the
command "uname -r" is:
2.6.11-auditor-10. I have downloaded the kernel source and i put them
in usr/src but i haven't compile the kernel. The problem is very
strange for me infact :

When I run iwpriv eth1 monitor 1 6, the following error occurs:
Interface doesn't accept private ioctl...
monitor (8BE8): Operation not permitted

I can see monitor when I run iwpriv eth1 so i think that i have just
the pacthed driver!!:

eth1 Available private ioctl :
force_reset (8BE0) : set 0 & get 0
card_reset (8BE1) : set 0 & get 0
set_port3 (8BE2) : set 1 int & get 0
get_port3 (8BE3) : set 0 & get 1 int
set_preamble (8BE4) : set 1 int & get 0
get_preamble (8BE5) : set 0 & get 1 int
set_ibssport (8BE6) : set 1 int & get 0
get_ibssport (8BE7) : set 0 & get 1 int
monitor (8BE8) : set 2 int & get 0

Does anyone know how to get this card into monitor mode?
i have to install however the pcmcia package and the pacth driver for
my orinoco gold with firmware 8.72 if yes which version i have to
install for my kernel???? then i have to compile the kernel without
support for pcmcia that it just present in my kernel
2.6.11-auditor-10?????..... HELP ME!!!!!!!!

Thanks