Not able to disable network adapter during repair

06-24-2005, 12:29 PM

Why do I have to unplug and then plug my dlink USB card to force it to get
the IP address. Once I do that it works perfectly so it seems the settings
must be correct but it will not connect automatically when booting up. Any
suggestions would be apprecieated

06-24-2005, 09:20 PM

Check the Dlink website for any updates for that card. What version of
Windows do you use?

"nocvad" wrote:

> Why do I have to unplug and then plug my dlink USB card to force it to get
> the IP address. Once I do that it works perfectly so it seems the settings
> must be correct but it will not connect automatically when booting up. Any
> suggestions would be apprecieated
>

06-27-2005, 02:49 AM

Windows XP Professional

"S Lane" wrote:

> Check the Dlink website for any updates for that card. What version of
> Windows do you use?
>
> "nocvad" wrote:
>
> > Why do I have to unplug and then plug my dlink USB card to force it to get
> > the IP address. Once I do that it works perfectly so it seems the settings
> > must be correct but it will not connect automatically when booting up. Any
> > suggestions would be apprecieated
> >

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Network enable/disable repair - now unable to	Chris Wrigley	Wireless Networks	0	03-29-2008 11:54 AM
disable netbios - net adapter vs. tcp/ip helper service	Mike55	Windows Networking	4	01-31-2008 08:00 AM
Loss of access, Disable/Repair NIC fails. 802.11g / b compatibility?	DC	Wireless Networks	6	12-30-2005 02:07 AM
possible to disable/enable wireless network adapter via command?	Arno	Wireless Networks	1	04-26-2005 12:39 PM
How to Disable/Enable Ethernet adapter under command line	Cliff Wang	Windows Networking	0	05-21-2004 03:50 PM