Hi,
For a a peer to peer n/w it is better to assign a static IP instead of
Automatic Private Address.Please do the following in both the laptop to
assign a static IP.
1) Go to Control Panel, Network connections
2) Then Right click the wireless n/w and click on properties
3) Then, highligt internet prtocol/TCPIP and then click properties
4) Select, use the following IP address and put in 192.168.1.5 as the IP
5) The subnet mask will be automaticall filled. Do the same in the ohter
laptop too.
Then, you also need to check a setting in ur wireless n/w tab in wireless
coneection properties. Make sure that you slecet your SSID and then click
configure. MAke sure that the check box "This is an Adh hoc nw" Is checked.
Also under the same wire n/w's tab, click on the advanced button and then
check the"Thsi is an Adhoc n/w radio button" Then you should be able to
connect provided both the workgroups are the same.
Regs
VInay.S
"BTInternet" wrote:
> In addition to the below situation I should add that despite the connection
> showing as "connected" and signal strength showing as "excellent" the laptop
> cannot get an IP address or DHCP gateway when "Repair Connection" is used.
> This is an ad-hoc peer to peer connection. Any ideas?
> -----------------
> I have set up an ad-hoc wireless network between a laptop and desktop. Both
> are running win XP. The networks connect to each other and show as
> "Connected" with excellent signal strength but no packets are exchanged only
> packets are attempted to be sent from both ends. Ad Hoc peer to peer is set
> up at both ends.
>
> The laptop assigns a Automatic Private Address but cannot get a Default
> Gateway. When the wireless connection is replaced with a traditional wired
> link between the two everything works just fine!
>
> I have tried switching off WEP & Network Authentication at both ends - no
> change, good connection but no packets exchanged.
>
> Why can the laptop not negotiate a Default Gateway with the Desktop. The
> laptop wireless link works fine when connected with other networks (though
> probably mostly wireless access points).
>
> Any help? Thanks John I
>
>
>
|