No authentication parameters displayed in XORP

When I enter:
../xorpsh -c "configure" -c "show -all protocols rip interface sat0 vif
sat0
address 10.0.1.219"

I get the following output:

[ 1970/01/03 02:14:48.245782 WARNING xorpsh RTRMGR ] [Operational
Command
File: /home/ini/xorptest/install/xorp/share/xorp/templates/misc.cmds
line
39]: Executable file not found: traceroute6
Invalid window width (0); window width unchanged (80)
Invalid window height (0); window height unchanged (25)
Welcome to XORP on localhost
root at localhost> configure
Entering configuration mode.
There are no other users in configuration mode.
[edit]
root at localhost# show -all protocols rip interface sat0 vif sat0
address
10.0.1.219
metric: 1
horizon: "split-horizon-poison-reverse"
disable: false
passive: false
accept-non-rip-requests: true
accept-default-route: true
advertise-default-route: true
route-timeout: 180
deletion-delay: 120
triggered-delay: 3
triggered-jitter: 66
update-interval: 30
update-jitter: 16
request-interval: 30
interpacket-delay: 50
[edit]

NOTE: There is no information regarding authentication.

Thinking that maybe nothing was output because I had not set up any
authentication, I entered:

../xorpsh -c "configure" -c "set protocols rip interface sat0 vif
sat0
address 10.0.1.219 authentication simple-password masterchef"

I ran the show command again and there was still no mention of the
authentication parameters.

How do I get the authentication parameters to be displayed?

I think that you are missing comand "commit" to complete the setting