Newbie: Orinoco RG-1000 problem. Please Help !!!

I am currently using AP Manager to config my RG-1000. I use my RG-1000
as router to connect to internet. This is the 1st time i use this to
config the RG-1000. The reason why i use the AP manager instead of RG
setup is because i want to change the SSID. I use RG Setup before
without any problem.

After finish setup using AP Manager.
I can only ping the rg-1000 from my desktop and other wirless station,
but i cannot connect to internet anymore.

This problem happens when the ADSL (PPPOE) option is enabled.
I always get the following error message

'When modem calls on demand and PPP encapsulation is selected, default
router serial interface must be initialized to the current interface
number'

What does it mean ???
Anything i need to change in order for me to get connect again ???

I am using 192.168.1.1 as the IP address of the router.
Can someone send me a sample config file as well, so i can check if
there's any mistake i make inside the config file for my rg-1000.

Also, after using AP Manager to config my RG-1000, i cannot config it
using RG-Setup again even i use the same network id .

What's wrong ??

Thanks in advance !!!

Vincent
(E-Mail Removed)

Use the default configuration supplied with the AP-Manager to set all
settings to defaults. Then try again.

(E-Mail Removed) (Captain 33) wrote in message news:<(E-Mail Removed). com>...
> I am currently using AP Manager to config my RG-1000. I use my RG-1000
> as router to connect to internet. This is the 1st time i use this to
> config the RG-1000. The reason why i use the AP manager instead of RG
> setup is because i want to change the SSID. I use RG Setup before
> without any problem.
>
> After finish setup using AP Manager.
> I can only ping the rg-1000 from my desktop and other wirless station,
> but i cannot connect to internet anymore.
>
> This problem happens when the ADSL (PPPOE) option is enabled.
> I always get the following error message
>
> 'When modem calls on demand and PPP encapsulation is selected, default
> router serial interface must be initialized to the current interface
> number'
>
> What does it mean ???
> Anything i need to change in order for me to get connect again ???
>
> I am using 192.168.1.1 as the IP address of the router.
> Can someone send me a sample config file as well, so i can check if
> there's any mistake i make inside the config file for my rg-1000.
>
> Also, after using AP Manager to config my RG-1000, i cannot config it
> using RG-Setup again even i use the same network id .
>
> What's wrong ??
>
> Thanks in advance !!!
>
> Vincent
> (E-Mail Removed)