Network Printer port resets on boot up

=?Utf-8?B?TG91IFNwbGVu?=

Guest

Posts: n/a

02-06-2005, 07:03 PM

I have an HP 1210 PSC printer attached to my desktop Pc running XP and shared
via network with my laptop running Windows 98. After setting the appropriate
port the laptop prints to the printer just fine. However, whenever I re-boot
the laptop, the port settings for the network print are changed on bootup. I
must then reset the printer port on the laptop in order to print again.

How can I prevent the port settings from changing every time the laptop is
re-booted?

Thanks, Lou

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How do I install the Deskjet 722C driver to function as a network printer rather than a dedicated PC parallel port printer	Warren	Windows Networking	7	10-29-2007 02:21 AM
remotely add a tcp/ip printer port	SEgerton	Windows Networking	1	02-16-2007 03:26 PM
Mapping the LPT1 Port to a network printer	Andy Siegel	Wireless Networks	4	11-24-2005 07:30 AM
MN-500 ethernet port use for network printer	=?Utf-8?B?ZGF2aXNtajcxMQ==?=	Broadband Hardware	1	05-21-2005 03:26 AM
Boot from EEPROM @ PCI-Card --> Boot from DHCPD/BOOTPD via Linux	Daniel Schwager	Linux Networking	3	07-06-2003 04:35 PM