Netgear WG311 causes POST failure

Michael Werts

Guest

Posts: n/a

10-03-2003, 10:10 PM

I recently purchased two WG311's. One installed on my wifes PC, a Celeron
500mhz works fine. The other, a Pentium 133 mhz, when I install the card in
a PCI slot, causes the POST to fail (i.e., no beep or system boot). The
system requirements specify that it needs a PCI 2.2 compliant slot - are
older pentiums not compliant and would that possibly cause this to fail?
What else could I do if that were the case?

Mike

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Netgear WG311 and LinkSys WRT%$g	Edward	Wireless Internet	3	11-21-2006 12:47 AM
NetGear Wg311- No connection	Jon	Wireless Internet	1	04-28-2005 04:49 AM
Netgear WG311 v2 no go	Pete	Home Networking	2	10-04-2004 10:41 PM
can't logon to domain using NetGear WG311	Dan Brill	Wireless Internet	1	06-01-2004 12:08 AM
perl CGI related: form post failure	Wenjie	Linux Networking	1	09-03-2003 06:37 PM