If you turn on the DHCP wthin the 900ap+ and then turn it off again
the machines seem to work. I was/am having similar problems and that
seemed to fix it. I added a range at the upper range of what my 614+
was giving out.
On Sat, 20 Sep 2003 16:11:26 +0200, "Peter Mairhofer"
<(E-Mail Removed)> wrote:
>Hi,
>
>We have a big Wireless LAN network with a few Accesspoints and
>omnidirectional antennas. We want to connect the the networks so
>that there is one network.
>
>There are a few separate networks and I have to connect them. So I
>have to configure my AccessPoint (D-Link DWL 900AP+) as Wireless
>Multipoint Bridge so that I can bridge between the three networks.
>
>But when the AP is in bridging mode, it does not accept clients any more,
>so I have no access to the WLAN with my own wireless clients.
>
>Is there a solution or a device that can act as a multipoint bridge AND as
>access point at the same time to solve my problem?
>
>I could have two access points but this isn't a good solution because
>I must not have more than one antenna on my roof so it would be great
>if there would be a solution that works with one antenna.
>
>Thanks a lot
>
>Peter
>
>
-- Have you checked your Smoke Detector...LATELY?
|
Similar Threads
Linear Mode
