"NAT Table FULL 400" - Eicon 2440.

10-17-2003, 02:50 PM

Hi guys,

anyone know what this means?

"NAT Table FULL 400" I have an Eicon 2440 router running 1.5 firmware
(latest apparently) I get this message alot in the router system log, it
fills up massively and i have to clear it as the thing starts to respond a
little slower.

I havent tied it down to a pattern yet unfortunately and even Eicon support
have no idea what it means. any ideas no matter how small?!

cheers in advance, Si.

10-17-2003, 03:20 PM

"..Si.." <(E-Mail Removed)> wrote in message
news:3f9001ad$0$103$(E-Mail Removed).. .
> Hi guys,
>
> anyone know what this means?
>
> "NAT Table FULL 400" I have an Eicon 2440 router running 1.5 firmware
> (latest apparently) I get this message alot in the router system log, it
> fills up massively and i have to clear it as the thing starts to respond a
> little slower.

I'm not familiar with this router, but if it has a parameter for NAT Ageing
then you could try reducing it.

Jc.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
any ideas on "ipv4: Neighbour table overflow"	Ralph Spitzner	Linux Networking	0	12-27-2011 11:45 AM
Re: WRT54GL not logging/showing for its "Incoming Log Table"?	Char Jackson	Network Routers	0	09-03-2010 10:03 PM
Re: SPEWS SLIMES "WindsorFox", "Kevin-!:?)", "Spin Dryer" get the cold shoulder at broadband ng!	SneakyP	Broadband	0	11-29-2005 10:46 PM
Attention Plus.Net Re: SPEWS DOLTS "WindsorFox", "Kevin-!:?)", "SpinDryer" SPAM braodband newsgroup	!:?)	Broadband	0	11-28-2005 03:03 AM
wireless access point, vpn, "routing table cannot be altered" error	Greg	Wireless Internet	4	01-06-2004 04:53 PM