Multiple MN-500 Basestations

I currently have a wireless network that uses the MN-500 basestation which
is connected to a cable modem that works just fine.

I have a different network set up in close proximity with another MN-500
that works just fine. All computers on this second network are wired to the
MN-500.

Is there a method (without buying additional software) to get the two
different networks which use separate MN-500s to act as a single network. I
want to access shared files and devices between the two networks.

I read through the manual and could not figure it out.

Thanks

Ron

Yes, I have my home LAN setup with two MN-500. One MN-500
is setup in the bridging mode. You can do this and still
retain the capability to manage the bridged MN-500 using
the BSMT. See this article and make sure you go to the
bottom of the page to see how to hook it up.

http://www.microsoft.com/windowsxp/u...working/expert
/bowman_segnet.mspx


>-----Original Message-----
>I currently have a wireless network that uses the MN-500
basestation which
>is connected to a cable modem that works just fine.
>
>I have a different network set up in close proximity
with another MN-500
>that works just fine. All computers on this second
network are wired to the
>MN-500.
>
>Is there a method (without buying additional software)
to get the two
>different networks which use separate MN-500s to act as
a single network. I
>want to access shared files and devices between the two
networks.
>
>I read through the manual and could not figure it out.
>
>Thanks
>
>Ron
>
>
>.
>