MN500 Port Forwarding Problems

I have the MN500 wireless router, and when I go to
the 'Persistent Port Forwarding' I enable a new field,
label it "pcAnywhere", allow ports 5631 to 5632, and set
it to TCP, and enter my computers last octet of the IP
address, and the inbound ports are the same, and when I go
and click 'Apply' the page takes a few seconds to refresh
as it is 'supposedly updating the router', and when the
page shows back up... what I just entered is GONE!!! It is
nowhere to be found. Why does the entry that I just made
get deleted?

Thanks in advance to anyone that can figure this one out.

Do you currently have a program using those ports when you
are trying to forward them for NAT purposes?

Thanks,

Chris Valentine


>-----Original Message-----
>I have the MN500 wireless router, and when I go to
>the 'Persistent Port Forwarding' I enable a new field,
>label it "pcAnywhere", allow ports 5631 to 5632, and set
>it to TCP, and enter my computers last octet of the IP
>address, and the inbound ports are the same, and when I
go
>and click 'Apply' the page takes a few seconds to refresh
>as it is 'supposedly updating the router', and when the
>page shows back up... what I just entered is GONE!!! It
is
>nowhere to be found. Why does the entry that I just made
>get deleted?
>
>Thanks in advance to anyone that can figure this one out.
>.
>

Try forwarding different ports.