Thanks! You are right. It was caused by some sites with
kind of worm. What was very strange to me is that the
firewall was disabled and the base station still block
the traffic. Anyway, seems to go away at least with the
two sites I was having problems.
>-----Original Message-----
>The "Connection attempt..." msgs indicate attacks or
port
>scans on your LAN that the firewall is blocking. This
>happens all the time. If you are getting a lot of them
>might be because of the recent worms on the Internet,
and
>that would explain slow traffic (and some lost pages).
It
>happens to everybody from time to time (although it
might
>be at different times, depending how the worm
>propagates), and after a few days it goes away.
>
>You may want to check the Internet speed. Open Command
>Prompt and enter tracert followed by the domain of a
site
>with problems to access (e.g. tracert cnn.com). This
will
>show you the time for each hoop on the Internet. Typical
>values are in 100's but if the connection is clogged you
>may see some * indicating a time out.
>
>Also, make sure you keep the firewall on all the times,
>and run a virus check on your computer.
>
>>-----Original Message-----
>>Since I did last published upgra (firmware V1.11.017),
>>the MN500 base station is blocking some incoming IP
>>packets when I try to open some we pages (Connection
>>attempt to base station from WAN blocked -- message in
>>the system log), resulting on web pages estremely slow
>or
>>never load. I do not have the base station firewall
>>enabled. I tried several setting changes but no one
>>resulted (including resets, factory defaults, and so
>on).
>>Does anyone have a clue on what is hapenning? It never
>>happens before.
>>
>>Mariano
>>.
>>
>.
>
|
Similar Threads
Linear Mode
