MN-720 Channel Setting

07-13-2004, 01:42 PM

I seem unable to set the channel on my adaptor, when I use
the Utility and go to the proper spot it is grayed out
because of the choice of using a gateway, if I choose peer
to peer I can change it, but it reverts back on it's own.
I got the thing to connect once when I ran the install Wiz
but after turning off system and back on, it will not
connect! Any Ideas? I checked for updates etc. but there
are none. djp

07-14-2004, 01:46 AM

Which version of Windows are you running? Have you installed any
service packs for that version of Windows?

David wrote:

> I seem unable to set the channel on my adaptor, when I use
> the Utility and go to the proper spot it is grayed out
> because of the choice of using a gateway, if I choose peer
> to peer I can change it, but it reverts back on it's own.
> I got the thing to connect once when I ran the install Wiz
> but after turning off system and back on, it will not
> connect! Any Ideas? I checked for updates etc. but there
> are none. djp

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Manual or Auto channel setting?	Clive	Wireless Internet	2	04-14-2007 06:54 PM
Wireless channel setting	Nunquam Rutilus	Home Networking	11	07-16-2006 06:37 PM
XP SP2 WZC - Setting channel number	dimaki	Wireless Networks	2	11-14-2005 11:25 PM
Which Channel(s) To Use?	Bill Steiner	Wireless Networks	6	03-25-2005 02:33 AM
workgroup channel vs. wireless adapter channel?	LoneGolfer	Broadband Hardware	3	05-18-2004 12:59 AM