MN-700 - Cannot Access Base Management / Setup

I cannot access the "Base Management Tool.." under the
tools menu and when I click on "Setup Wizard" nothing
happens.

Sofware seemed to install fine, and I get the "Microsoft
Broadband Network Utility" screen / icon in the tray.

I just cant configure or do a set-up. This modem was set-
up previously on this system, but I got new hardware and
wiped the drive and did a fresh install on a formatted
drive.

Any help would be greatly appreciated.

Thanks.

I have already tried unplugging the router for 5+ minutes
as well.

The router stores the connection information inside itself. So you
don't need to reprogram or reconfigure the router.

(E-Mail Removed) wrote:
> I have already tried unplugging the router for 5+ minutes
> as well.

I would still like to be able to access the settings
though.

I can't even get to them via my web browser. I get
gateway timeouts. I can browse the web fine, just cant
connect to the router.



>-----Original Message-----
>The router stores the connection information inside
itself. So you
>don't need to reprogram or reconfigure the router.
>
>(E-Mail Removed) wrote:
>> I have already tried unplugging the router for 5+
minutes
>> as well.
>
>.
>

if you have a wireless connection, just open your browser
and go to 192.168.2.1. If you don't have wireless
connection, hook up a wired computer and do the same as
above. This will always take you to the base station mgt
tool
>-----Original Message-----
>I would still like to be able to access the settings
>though.
>
>I can't even get to them via my web browser. I get
>gateway timeouts. I can browse the web fine, just cant
>connect to the router.
>
>
>
>>-----Original Message-----
>>The router stores the connection information inside
>itself. So you
>>don't need to reprogram or reconfigure the router.
>>
>>(E-Mail Removed) wrote:
>>> I have already tried unplugging the router for 5+
>minutes
>>> as well.
>>
>>.
>>
>.
>

Try locating your computer's workgroup name, and checking
it for illegal characters as described in this support
article:
http://support.microsoft.com/default.aspx?scid=kb;en-
us;833768

Then try restarting the Setup Wizard.

DK


>-----Original Message-----
>I cannot access the "Base Management Tool.." under the
>tools menu and when I click on "Setup Wizard" nothing
>happens.
>
>Sofware seemed to install fine, and I get the "Microsoft
>Broadband Network Utility" screen / icon in the tray.
>
>I just cant configure or do a set-up. This modem was set-
>up previously on this system, but I got new hardware and
>wiped the drive and did a fresh install on a formatted
>drive.
>
>Any help would be greatly appreciated.
>
>Thanks.
>.
>