MN-520 cannot connect to Netgear MR814v2

went through setup successfully except it had to update
my windows 98 software but computer turned off due to
power failure.. wasn't sure if it was done yet.

power light is on, wireless light periodically blinks
but no connection to network, i have successfully
connected to network with computer 2 floors away. i'm in
same room as router. router requires WEP key and
broadcasts an SSID but 520 doesn't see it.

not sure what to do next. changed my advanced threshold
to 3204 or watever was noted with Linksys router just to
see if it worked but still no seeeing of router!
please help
parag

Go to the Network properties and look for the wireless
TCP/IP conncetion. If it's not there, it did not
install...

Otherwise, check the settings. Make sure the SSID,
channel, WEP key, and WEP key length match those on the
router. Check also the Workgroup name -- it needs to
match the workgroup on the other computer.

The best way is typically to turn off WEP, setup and test
everything, and then add WEP.

>-----Original Message-----
>went through setup successfully except it had to update
>my windows 98 software but computer turned off due to
>power failure.. wasn't sure if it was done yet.
>
>power light is on, wireless light periodically blinks
>but no connection to network, i have successfully
>connected to network with computer 2 floors away. i'm in
>same room as router. router requires WEP key and
>broadcasts an SSID but 520 doesn't see it.
>
>not sure what to do next. changed my advanced threshold
>to 3204 or watever was noted with Linksys router just to
>see if it worked but still no seeeing of router!
>please help
>parag
>.
>