I have 2 out of the 3 computers connected. One computer
has the base station and the other is using the MN-510
adapter and they connect fine on WinXP. The third
computer is also using a MN-510 adpater but, will
recognize the Wireless Access Point but will not
connect. All usb ports are functional, TCP/IP are all on
obtain DNS and IP and not static, tried with original
software and updated software and get nothing. However,
when configuration wizard runs and sees the basestation
it tells me "Incorrect WEP key" when WEP is not activated
on the basestation. *Note* the basestation has also been
reset along with the broadband modem. I have also tried
to make a static ip manually in the TCP/IP configuration
to connect to the basestation, when completed the system
then see's the two computers but refuses to connect to
the internet. I have even tried to use a WEP on the
basestation to connect and yet it says "invalid WEP key"
When obtain DNS and IP are enabled in the TCP/IP setup
and then running the config wizard on the MSBN again it
will not connect at all to the basestation even though it
list's the proper SSID name. This system is running
Win2k. Help?
|
Similar Threads
Linear Mode
